Usage
ASIDA-JK3200 Inspection Hole Machine is used to inspect completed PCBs for drill-hole defects. The number and quality of drilled holes is checked and the board is assigned to be either OK or NG, the resulting PCBs are sorted accordingly.
Characteristics
• User friendly interface, no special training required.
• Long bar LED light source.
• Detection speed can reach up to 12.5m/min.
• 30 degree angle detection range, inputted boards can be off centre by up to 30 degrees.
• Capable of checking two boards simultaneously.
• Network maintenance function, can link to other systems to display OK/NG information.
• Personalised software designed to specific customer requirements.
Usage
ASIDA-JK3200 Inspection Hole Machine is used to inspect completed PCBs for drill-hole defects. The number and quality of drilled holes is checked and the board is assigned to be either OK or NG, the resulting PCBs are sorted accordingly.
Characteristics
• User friendly interface, no special training required.
• Long bar LED light source.
• Detection speed can reach up to 12.5m/min.
• 30 degree angle detection range, inputted boards can be off centre by up to 30 degrees.
• Capable of checking two boards simultaneously.
• Network maintenance function, can link to other systems to display OK/NG information.
• Personalised software designed to specific customer requirements.
Technical Parameters
item
Specification
Model
JK3600
Range of pore size
0.15～10mm
Board size
100×1500mm～630×650mm
PCB thickness
0.3mm～10mm
The maximum number of holes
No limit
Inspection speed
3.0～12.5m/min
Inspection accuracy
±40µm
Hole tolerance
±40µm
Hole margins
≥0.15mm
Inspection method
Closed CIS measurement
Inspection light source
LED light source
Power requirements
AC220V 50Hz
Machine size
3550mm×1200mm×1100mm
（L×W×H）
Pressure capacity requirements
0.5～0.7Mpa
Weight
450kg